Bangle core, Stainless Steel 2 piece
Size 7.5 Bangle size ( 61.50 mm / 2.42 inches )
Size 8 Bangle size ( 64.90 mm / 2.55 inches )
Inlay Material width 0.7110 inches/ 18.06 mm, min blank size needed is approx 3 inches / 74 mm
Total overall finished width .87 inches / 22.13 mm
Graded 316 Stainless steel and fully polished exterior, threaded 2 piece bangle
Project blanks available separately or as a Combo Pack
Bangle making instructions
1.Find the center of blank and mark
- Mount blank in a chuck and align the center
- Use a hole saw or forstner bit to cut a hole undersize to final dimensions needed, based on bangle size. Care is needed to prevent heat buildup
- Turn the inside hole to the dimension of the inside of bangle channel (based on bangle size)
- Face the blank flat and rotate in chuck or turn to final width of inlay.
- Glue the inlay in bangle channel and screw blank together (we recommend testing dry before applying glue)
- Mount and turn the bangle to final size
- Sand and Finish the bangle
- Polish and clean any glue left on the bangle.